Epoxy & Polyaspartic Garage Floor Coatings in St. Augustine, FL

Our garage floor coatings start at $2,500. Most projects run about $6 to $9 per square foot, so a standard 400 sq ft two-car garage is typically $2,500–$3,600 and a 600 sq ft three-car garage $3,600–$5,400. The final price depends on the condition of the concrete, crack or pitting repair, how much grinding is needed, the coating selected, and total square footage. Every job gets a free on-site estimate with a written price before work starts; the starting price is a guide, not a guaranteed quote.

Epoxy bonds extremely well to properly ground concrete and, in a moisture-vapor-barrier formulation, resists moisture coming up through the slab, which makes it the right base coat for Florida garages. Polyaspartic is UV-stable, highly abrasion- and chemical-resistant, and resists hot-tire pickup, which makes it the right topcoat. We install both: an MVB epoxy base coat with decorative flake, sealed under a clear polyaspartic topcoat.

Not with a properly installed system. Hot-tire pickup happens when a coating is poorly bonded or too thin, which is common with DIY epoxy kits and single-coat installs. We diamond-grind the slab for a mechanical bond, build the floor in layers, and finish with a polyaspartic topcoat rated for hot-tire resistance.

A standard two-car garage usually takes 1 to 2 days of on-site work: diamond grinding and repairs, the epoxy base coat, flake broadcast to full rejection, scrape-back, and the polyaspartic topcoat. Heavy repairs, a larger slab, or weather can add time, and we tell you the schedule before we start.

Light foot traffic is typically possible within about a day, and we confirm the exact window for the specific products on your floor. We ask you to keep vehicles off the floor for roughly 7 to 10 days so the coating reaches a full cure. Parking too early is the most common way a good installation gets damaged, so we would rather give you a conservative number than a fast one.

Preparation and build. Kits rely on an acid etch instead of diamond grinding, which does not open the concrete profile properly, and they are a single thin coat of material that is not UV-stable, so it ambers where sunlight reaches through the door and lifts under hot tires. A professional full-flake system is mechanically ground, repaired, built in multiple layers with industrial-grade materials, and sealed under a polyaspartic topcoat.

Yes. Oil and contaminants are removed during preparation and saturated spots get extra treatment before grinding. Surface cracks, pitting, and spalling are repaired and filled before the base coat goes down. If we find active structural cracking or moisture coming up through the slab, we tell you before quoting rather than coating over a problem.

A full-flake floor has texture from the flake itself. Where more traction is needed, such as a garage that gets wet, a sloped floor, or an outdoor surface, we add aluminum oxide anti-slip grit to the topcoat.

Yes. We coat concrete lanais, covered patios, front porches, walkways, and selected pool-deck and outdoor concrete surfaces. Outdoor surfaces are specified differently from an enclosed garage because of sun, moisture, and slip-resistance requirements, so the preparation, additives, and products are matched to the surface rather than copied from the garage.

Yes. We are based in Saint Augustine and install garage floor coatings throughout St. Johns County, including St. Augustine Beach, Nocatee, Ponte Vedra, Ponte Vedra Beach, World Golf Village, SilverLeaf, Fruit Cove, and Julington Creek, with no travel charge within our core service area. We also take projects in Green Cove Springs, Jacksonville, and Palm Coast.